Chip Pan

[TheMrAxeman]

can someone please tell me if i have miscalculated anything because some of the measurements contrast with eachother
it would help alot if someone could give me the exact width and length of the volume pedal

[tekker]

can someone please tell me if i have miscalculated anything because some of the measurements contrast with eachother
it would help alot if someone could give me the exact width and length of the volume pedal

The footplate (which you put your foot on) is 4 and half inch wide & 11 and half inch long (or 116 x 287 millimeters).

[TheMrAxeman]

where did you buy that i really want one!

[matt21]

where did you buy that i really want one!

They appear on ebay once in a while if you find it in time. It's the Roland FV-2

[TheMrAxeman]

how tall is the bottom

[TheMrAxeman]

Ok I remeasured and this is what i got based off of the wah and the volume
slanted edge is 5 and a half in
there is 1 and 1/5 of an inch of space above the stomp switch
pedalboard enclosed area 2ft 6 in wide and 13 in deep
pedalboard whole 3ft 6 and a half in wide and 15 in deep
each stomp switch 2 and a half in wide 3 in in tall
top flat piece 2ft 6 in wide and 8 in deep
the edge is 2 in tall
the pedalboard actually lies about 1 in from the top of the edge of the gun case
five wires coming out the back
two extra inputs (maybe for external pedal like the boss od-1 he used for a while)
height in back is about 2 in(not counting the gun case edge and it actually is 1 in taller from where the pedalboard lies in the gun case)
space between stomp switches 1 and a half in
feel free to correct me

[wareagle]

honestly the newer volume pedals are better.... check out the erinie ball... it does however take off a bit of top end... but if you want one that doesnt you get very steep prices.

[matt21]

I found these dimensions online from someone who owned one. 31 cm. long x 13 cm. wide x 7.0 cm. high. Knowing there's 2.5 cm. to an inch, it equates to 12.4 in. long x 5.2 in. wide x 2.8 in. high

[TheMrAxeman]

ewww i hate the ernie ball way too sensitive for me

[TheMrAxeman]

wait so is it 4 and half inch wide & 11 and half inch long or 12.4 in. long x 5.2 in. wide x 2.8 in. high

[tekker]

wait so is it 4 and half inch wide & 11 and half inch long or 12.4 in. long x 5.2 in. wide x 2.8 in. high

The footplate (which you put your foot on) is 4 and half inch wide & 11 and half inch long (or 116 x 287 millimeters) the base is a little wider...
Measured mine FV-2..

[wareagle]

too sensitive??thats what you want... i hate the crybaby style because its all or nothing and the sweep system isnt smooth..

[TheMrAxeman]

i mean i dont like that when you pull it back all the way you cant hear anything i want one where i can set the min and max...thats what i meant by sensitive

[TheMrAxeman]

thanks tekker i didnt see ur reply i measured it from the foot panel so it should be accurate

[TheMrAxeman]

i am making a replica of the chip pan based on these measurements you can watch my progress here viewtopic.php?f=15&t=4535
i dont wanna keep taking up space in the general section